THIS DOCUMENT DESCRIBES PATENTABLE MATERIAL, DO NOT GIVE TO THE PUBLIC OR ANY PARTY THAT WOULD RESULT IN WAIVING OF OUR PATENT -> IT’S FUTURE PROFITABILITY WILL FEED AFRICA
(62% of profits will go to World Vision, 10% to local charities)
George Paul Molson
<georgemolson@gmail.com>
688 Gilchrist Peterborough, ON
Canada K9H 4P3
Tati Rodriguez
( partner of George when this document was first conceived )
Free Energy Critical Principles
When an electromagnet possesses an iron magnetic core, the strength of its magnetic field is roughly doubled. A consistent magnetic field such as the ones found in permanent magnets cannot do work alone, but rather it needs to be permanent magnetization in motion ( A permanent magnet flipping in polarity within a coil acts the same as a permanent magnet which is in motion and ideally fluctuates in permanent magnet capacity following a sinusoid ).
A Leedskalnin PMH is used to accomplish this. The reason it works is:
- The magnetic field created in the iron core is permanent
- the permanent magnet field is in motion (by virtue of alternating polarity following a sinusoid)
- collection coils picks up the fluctuating permanent magnetic field
The magnetic field collected is stronger due to the amplification in the metal bar and this amplification is now exploitable due to the fact that it flips polarity and the magnetism created is permanent.
Leedskalnin PMH
The magnetic field collected is stronger due to the amplification in the metal bar and this amplification is now exploitable due to the fact that it flips polarity and the magnetism created is permanent.
The magnetic field collected is stronger due to the amplification in the metal bar and this amplification is now exploitable due to the fact that it flips polarity and the magnetism created is permanent.
This is achieved by alternating the polarity of the magnetic bar and inner coil following a sinusoid where North-South and South-North are the upper limit and lower limit of the sinusoid and complete demagnetization of the bar the zero-point. At the top of the wave (max magnetization in either direction/polarity) the magnetism has to be depleted at a sinusoidal rate by impeding the rate of cancellation of the short circuit using a resistor and wiring the two coils so that they will dispose of the permanent magnetisation at a rate following a sinusoid.
From the zero-point (when there is no magnetism), The PMH needs to be activated (intensity in magnetism ), at a rate of increase that follows a sinusoid and cease adding energy once the magnetism of the bar reaches saturation. A microcontroller is needed for this and what it does is based on knowing how much energy needs to be added to increase permanent magnetisation in the PMH by placing current on the circuit of the four terminals of the coils of the two ends of the PMH so that they reinforce one another:
Tesla [expired] patent #512,340
Use a Tesla Bifilar coil as above as shown
Using AC enables much higher throughput of the device (the amount of energy that the device can handle as it is less harmful to the wires and the thin copper cable can conduct more power) and how many times the process is repeated as the magnetization of the iron bar occurs faster with the Tesla bifilar coil below, throughput being improved by the number of times the process can be repeated per second. K is still equal to 2x and is like the fuel efficiency with regards to inputted energy.
The rate of the polarity flipping being repeated more rapidly is like the RPM’s of a motor. The rate of energy generation depends upon the K value of the device x the number of times the process can be completed / second.
The energy is collected in an outer collection coil which encloses the inner (seeding coil / male coil), and the metal bar ( amplification bar / male component). A Tesla Bifilar coil is used in both coils (seeding coil [male] and receptive (collection) coil [female]) so that the speed of the coils firing can be maximized to increase generator output [read patent image below]. Ideal dimension (they can be varied) is 1” bar, inner [seeding] coil of outer diameter of 3”, and collection coil of 5” diameter on outside.
This coil design is to be used as for both the inner [seeding] and outer [collection] coils for advantages listed above.
Petition to the Lord
Please manifest an overunity phenomenon which directly Violates the Principle of Conservation of Energy so that the wars may end, The hungry may be fed, and to demonstrate to the public the importance of Anomalies Research
Free Energy is entirely mechanistic and evidence of intelligent design as the laws of physics support the creation of Energy in just the right place. The critical insight that makes it work is that the magnetic field in the device when an iron bar is in the center and is 2x as strong as the field created by the inner electromagnet (k=2). This is because the iron bar also becomes a magnet approximately doubling the size of the field. The next challenge we face is that a stationary magnet cannot induce a magnetic current, but rather needs to be in motion or reversed in direction (by flipping its polarity) which is accomplished by sending electricity through the inner coil and causes the bar to be magnetized and remagnetized with the opposite polarity ideally with AC (for higher throughput) and with the amount of permanent magnetization of the iron bar following a sinusoid. The outer coil collects the amplified magnetic field which is flipping polarities rapidly.
One final insight is needed: we need to convert electromagnetism into permanent magnetization. This is accomplished with a Leedskalnin PMH by connecting the two coils on the ends of the PMH opposing one another in terms of their magnetic polarity and connect them in a short circuit and tap the two ends of the wires of opposing polarity to permanently magnetize the iron, see video. The two coils must reinforce one another magnetically for this to happen. K is still = to 2 so the amount of total energy (measured in action potential of the iron bar) to have an effect on the coil is doubled every time the magnetization of the iron bar switches polarity. Electricity is generated when an injected pulse of the correct amount (equal to the capacitance of the PMH) flips the polarity of the iron core using half as much energy to create the permanent magnetization as the new magnet can potentially deliver [it’s action potential / cycle]; (k [relative amplification] =2).
This process can be repeated as quickly as the permanent magnet can be created (converted to permanent magnetism), reversed, and reinforced by the two coils connected to each other in a short circuit when assembled in it’s helical configuration. Using the tesla coil on the ends of the PMH increases the throughput (the number of times the process can be repeated per interval) and yet the amplification in the iron bar (k=2) 3:29 is what creates the overunity amplification of permanent magnetization in the iron bar.
Leedskalnin PMH
In Memory of Edward Leedskalnin
The critical insight is that magnification of a magnetic field by a metal bar being subjected to an induced magnetic field that is flipping in polarity results in amplification of current (k=2). Collectively these processes result in the generation of energy.
If a developer comes about that is willing to give 72% of the proceeds to those who need it most (62% for World Vision & 10% locally) please put them in touch with me or if I have passed please circulate this document so everyone will know how it works once it is demonstrated and have the governments nationalize it in accordance with their interpretation of my will and may adapt it if sound cause arises. It surely will.
The government is eligible to become this contractor and would be qualified to do so if it meets the above terms and is willing to support the Basic Income Guarantee. I regard that Canada is in good stead under leadership of Justin Trudeau and would like to start the process of nationalization as soon as the device is demonstrated or even concurrently. The process of nationalization should happen ASAP but should be based on a constitution and should involve consulting with the right parties as I do not know all the details and other people should weight in. The government has supported me and without its support I would not be here. I would like to be able to repay my debts and reward the people who have helped me. It is also possible that I may be more useful to the planet if I had enough to develop my ideas and fulfill a vision I have and I am committed to.
I regard that once ANTEKK is developed it should be nationalized and yet kept arms-length by a contract that will determine the constitution of ANTEKK which the government of Canada may execute. Other nations may work with Canada to also create nationalized solutions for their nations if they are willing to spend the proceeds on their people in the form of a basic income or worthy social programs at the discretion of Canada (I believe a 15% overhead is achievable). [ the details of this paragraph may need to be refined ]. You already have my moral authority that once the patent expires to continue taxing Free Energy so that it funds a basic income guarantee or worthy social programs as is needed. I seek to come under direction of someone or an organization of sound merit.
We currently are underfunded to re-develop the idea after our first model was dismantled by the Police. In the event of my passing please develop and share this idea to help the world as much as possible.
Yours Very Truly,
-George Molson
See also:
Iron Core Solenoid – k value > 1 indicates overunity potential
“What science has described as ‘Relative permeability’ is relative amplification. This is a logical fallacy” – George Molson
http://hyperphysics.phy-astr.gsu.edu/hbase/magnetic/elemag.html#c5
Magnetic Current by Edward Leedskalnin
http://magneticuniverse.com/discussion/98/ed-leedskalnin-magnetic-current-illustrated-pdf-version
Free Energy featuring Aisha by Elevate Foundation
Donations can be made to:
St. John the Evangelist Anglican Church
99 Brock St.
Peterborough, ON K9H 2P2
Phone: (705) 745-7624 | Email: office@stjohnspeterborough.ca
George Paul Molson
Founder, ANTEKK
ANTEKK - Beyond Belief 